rabbitklion.blogg.se - Datatool s4 red

DATATOOL S4 RED INSTALL

Configuring the Alarm to Suit the Customers’ Requirementsĭue to the design of the EvoPlus series it is possible to configure the system in several ways.

System memory (remembers the last state in which it was left if the battery is disconnected)Ĥ.

Additional negative output to trigger secondary device (e.g.

Bike finder via flashing indicators or side lights (depending on installation).

Arm/disarm chirps (Selectable when arming or disarming).

Automatic arm / re-arming (Selectable, re-arms alarm if disarmed by remote and ignition is not switched on).

PIN override (factory set, non-adjustable) suitable for key or keyless ignition vehicles.

Single engine immobiliser circuit – suitable for use on ‘normally open’ or ‘normally closed’ vehicle circuits.

The Datatool Evo Plus has the following specification:

This alarm system is intended for use on motorcycles or scooters, with or without a factory immobiliser system. If you require further assistance in choosing the correct alarm system then please contact details of the motorcycle/scooter requiring the alarm. Scorpion Automotive Ltd cannot be held responsible for incorrect choice of product or costs incurred removing an incorrectly specified alarm.

DATATOOL S4 RED INSTALL

Please note that this system is not an insurance-approved product, if insurance approval is an important criteria for your customer then you should look to install a Datatool S4 Series alarm or equivalent. It is critical the correct alarm system is chosen to suit the customers’ requirements.